Rubber bellows and gaiters can be produced in a range of materials and if required a variety of colours (depending on the elastomer). These products can be used to protect, shield and isolate sliding and rotating mechanisms.


From our specialist manufacturing facility, sizes can range from under 5mm diameter, with ultra thin walls to ensure minimum interference to the protected areas, to products over 1,000mm in diameter used to connect the air intakes on jet turbines.


With our ability to supply materials for use in hostile environments, and field leading expertise. TRP is well placed to advise on your application.


Under some circumstances bellows can be used as actuators, being sucked or blown allowing for "stiction free" movement.


If you require any additional information please contact us, our team are available to discuss your requirements.